ALTRACO ELECTRONIC DISC BRAKE CALIPER Specifikace stáhnout pdf (Strana 15)

Section 3

Inspection

6. Inspect inlet fitting and O-ring for damage.

Replace O-ring if necessary.

7. Inspect the linings as described earlier in this

section.

8. Inspect caliper ports and end plate bolt holes

for thread damage. Refer to the table below.

A. Use the appropriate taps lubricated with

light oil to inspect tapped holes for thread

damage and to clean minor thread damage.

B. Replace components with thread damage

that you cannot repair. Use a thread tap to

repair minor damage.

9. Discard all back-up rings, O-rings and dust

boots. Install new ones when you assemble the

caliper.

Area to Inspect Tap Size to Use

Bleeder ports 0.4375-20 UNF

End plate bolt holes 0.6250-11 UNC

Inlet port 0.5000-20 UNF

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 24 25

Žádné komentáře

ALTRACO ELECTRONIC DISC BRAKE CALIPER Specifikace Strana 15